1. Rotate to dismount the plug, turn on the water source, clean the inlet hose, and ensure there is no sand or foreign matter to prevent blockage during use.
2. Wrap PTFE tape clockwise around the G1/2 thread on the water inlet of the angle valve. If the angle valve has a decorative cover, mount it onto the angle cover first. Connect the angle valve to the water inlet connector by rotating them (tighten with a spanner). Install the angle valve according to the signs for cold and warm water.
3. Turn on the water source and then turn off the angle valve. After 5 minutes, check for leaks in the inlet hose and angle valve.